Cut circles into tiles

Most bathrooms require at least one hole in tiles for a floor or shower waste outlet, or for a toilet and pedestal if you are tiling an existing bathroom layout. For efficient water run-off, position the circle at the intersection of two or four tiles rather than cutting into a single tile.

 

YOU WILL NEED:

Angle Grinder
Diamond blade with a smooth, continuous rim
Diamond tipped tile scorer
Tile nipper

HERE'S HOW:

1. Score the circle outline
Mark the circle on the tiles then score the profile with a diamond tipped tile scorer. Follow this mark with the angle grinder, applying light, gentle pressure to the surface of the tile.

2. Easy removal
Before removing the excess tile, make short cuts on both sides of the semicircle (A and B). Connect the cuts (C) by making a series of progressively deeper shallow cuts.

3. Make short radial cuts
Complete the semicircle with a series of spoke-like radial cuts (see image bottom right). Clean up rough edges with a diamond blade or remove tabs with a tile nipper.

4. Clean up
Grind the edges smooth, working slowly around each curve.

Go shopping:

Use Tork Craft Diamond Tipped Blades for best results. We recently used these blades in our DIY Divas Advanced Power Tool Workshop and were extremely impressed with the result.